Auxiliary Sketches

Lets you specify the creation of an auxiliary sketch.

To set options:

·                Click Tools option from the pull down menu, then Options.

·                Select the General tab.

·                Select the Draw Auxiliary Sketches check box for GearTrax to create a sketch as the model is created.

·                Select Pitch Diameter if you would like the pitch diameter included on the sketch.

·                Select Addendum Diameter if you would like the addendum diameter included on the sketch. This option will be ignored if it does not apply to the product being modeled.

·                Select Dedendum Diameter if you would like the dedendum diameter included on the sketch. This option will be ignored if it does not apply to the product being modeled.

·                Select Base Diameter if you would like the base diameter included on the sketch. This option will be ignored if it does not apply to the product being modeled.

·                Select Hide sketch on creation if you would like GearTrax to hide the sketch as the model is created.